We used cosmogenic radionuclides in detrital river sediment to measure erosion rates of watersheds in central Cuba; erosion rates are lower than rock dissolution rates in lowland watersheds. Data from two different cosmogenic nuclides suggest that some basins may have a mixed layer deeper than is typically modeled and could have experienced significant burial after or during exposure. We conclude that significant mass loss may occur at depth through chemical weathering processes.

Cosmogenic nuclides are a tool to quantify denudation – the total removal of mass from near the Earth's surface. Chemical weathering can introduce biases to cosmogenic-nuclide-based denudation rates measurements. Here, we investigate the effects of weathering on cosmogenic nuclides and develop tools to correct for this influence. Our results highlight which additional measurements are required to determine accurate denudation rates in regions where weathering is not negligible.

Dating low-grade metamorphic rocks with the ⁴⁰Ar / ³⁹Ar method is difficult because samples are fine-grained mixtures between detrital and newly grown metamorphic minerals. We use a careful step-heating schedule and resolve limits within the complex age spectra thus derived to infer the timing of metamorphism and deformation in the Delamerian Orogen (formerly part of eastern Gondwana). Results suggest detrital mineral from up to 1172 Ma and that metamorphic minerals grew at 470–458 Ma.

Apatite and zircon are the most widely used minerals for dating rocks, but they can be difficult to identify in some crushed rock samples. Incorrect mineral identification results in wasted analytical resources and inaccurate data. We show how X-ray computed tomography can be used to efficiently and accurately distinguish apatite from zircon based on density variations, and provide non-destructive 3D grain-specific size, shape, and inclusion information for improved data quality.

Mineral grains within sediment or rock absorb a radiation dose from the decay of radionuclides in the host matrix. For the beta dose component, the estimated dose rate must be adjusted for the attenuation of beta particles within the mineral grains. We show here that the mean dose rate to dosimeter grains in a granular matrix is dependent on the grain-size distributions of the source grains, the bulk sediment, and the grain size of the dosimeters.

When first introduced together with the depth profile technique to determine the surface exposure age, the linear inversion approach has suffered with the drawbacks of not incorporating erosion and muons into calculation. In this paper, we increase the accuracy and applicability of the linear inversion approach by fully considering surface erosion, muogenic production, and radioactive decay, while maintaining its advantage of being straightforward to determine an exposure age.

Noble gases are largely excluded from minerals during rock formation, but they are produced by certain radioactive decay schemes and trapped in mineral lattices. However, they are present in the atmosphere, which means that they can be adsorbed or trapped by physical processes. We present details of a troublesome trapping mechanism for helium during sample crushing and show when it can be ignored and how it can be easily avoided during common laboratory procedures.

Secondary ion mass spectrometry (SIMS) is the oldest and most sensitive analytical technique for in situ U–Pb geochronology. This paper introduces a new algorithm for SIMS data reduction that treats data as compositional data, which means that the relative abundances of ²⁰⁴Pb, ²⁰⁶Pb, ²⁰⁷Pb, and ²³⁸Pb are processed within a tetrahedral data space or simplex. The new method is implemented in an eponymous computer programme that is compatible with the two dominant types of SIMS instruments.

Advancements in technology have introduced new techniques to more quickly and cheaply date rocks with little sample preparation. A unique use of this method is to date shales and constrain when these rocks were first deposited. This approach can also time when such sequences were subsequently affected by heat or fluids after they were deposited. This is useful, as the formation of precious-metal-bearing systems or petroleum source rocks is commonly associated with such processes.

U–Pb dating by the in situ laser ablation mass spectrometry (LA-ICPMS) technique requires reference materials of the same nature as the samples to be analysed. Here, we have explored the suitability of using carbonate materials as a reference for sulfates, since there is no sulfate reference material. The results we obtained are satisfactory, and thus, from now on, the sulfates can also be analysed.

Cryogenic cave carbonates (CCCs) provide a marker for past permafrost conditions. Their formation age is determined by Th / U dating. However, samples can be contaminated with small amounts of Th at formation, which can cause inaccurate ages and require correction. We analysed multiple CCCs and found that varying degrees of contamination can cause an apparent spread of ages, when samples actually formed within distinguishable freezing events. A correction method using isochrons is presented.

Apatite helium thermochronology is a method that dates the time at which a rock (and the apatite crystals contained within) cooled below a certain temperature by measuring radioactive parent isotopes (uranium and thorium) and daughter isotopes (helium). This paper proposes a revision to a commonly used calculation that corrects raw data to account for instances when the analyzed apatite crystals are fragmented. It demonstrates the improved accuracy and precision of the proposed revision.

We apply quartz ³He paleothermometry along two deglaciation profiles in the European Alps to reconstruct temperature evolution since the Last Glacial Maximum. We observe a ³He thermal signal clearly colder than today in all bedrock surface samples exposed prior the Holocene. Current uncertainties in ³He diffusion kinetics do not permit distinguishing if this signal results from Late Pleistocene ambient temperature changes or from recent ground temperature variation due to permafrost degradation.

This study is focused on the accurate measurement of U and Th by wet chemistry and laser ablation methods to improve (U–Th)/He dating of magnetite and spinel. The low U–Th content and the lack of specific U–Th standards significantly limit the accuracy of (U–Th)/He dating. Obtained U–Th results on natural and synthetic magnetite and aluminous spinel samples analyzed by wet chemistry methods and LA-ICP-MS sampling have important implications for the (U–Th)/He method and dates interpretation.

Absolute chronological constraints are crucial in Earth and planetary sciences. In recent years, U–Pb dating of carbonates has provided information on the timing of, for example, diagenesis, faulting, or hydrothermalism. These studies have targeted relatively young terrestrial carbonates up to 300 million years old. By dating 3.9 billion-year-old martian carbonates in situ using the U–Pb chronometer, we show that this system is robust in ancient samples that have had a relatively simple history.

If topographical obstructions are present in the surroundings of sampling sites, exposure ages of rock surfaces need to be corrected. A toolbox for the ESRI ArcGIS software allows for quantifying topographic shielding with a digital elevation model, but it has only been validated with few field data. In this study, the output of the toolbox is evaluated with a more extensive dataset. If suitable elevation data are chosen, the toolbox provides a sound approach to determine topographic shielding.

We constrained deposition phases of fluvial sediments (NE Belgium) over the last 1 Myr with analysis and modelling of rare isotopes accumulation within sediments, occurring as a function of time and inverse function of depth. They allowed the determination of three superposed deposition phases and intercalated non-deposition periods of ~ 40 kyr each. These phases correspond to 20 % of the sediment age, which highlights the importance of considering deposition phase when dating fluvial sediments.

Deposits left behind by past glacial activity provide insight into the previous size and behavior of glaciers and act as another line of evidence for past climate. Here we present new age control for glacial deposits in the mountains of Montana and Wyoming, United States. While some deposits indicate glacial activity within the last 2000 years, others are shown to be older than previously thought, thus redefining the extent of regional Holocene glaciation.